2.1.7. Ethernet Network Connections
ETHERNET
This RJ-45 connector is an Ethernet port used for high-speed firmware upgrades as well
as FTP logo transfers. See section 2.8 for information on connecting to an Ethernet network.
See section 3.6.4 in the General menu descriptions for information on configuring the
network addresses for the keyer.
2.1.8. Power Connections
The 9625LG Series Keyer main unit has one or two (redundant supply is optional) universal power
supplies that operate on 100 to 240 Volts 50/60 Hz AC. The optional Remote Control panels are
supplied with a universal input (100 to 240 volts AC at 50 or 60 Hz) 12 VDC power adapter.
2.2.
MOUNTING
The 9625LG Series Keyers are equipped with rack mounting angles and fit into a standard 19 inches
by 1.75 inches (483 mm x 45 mm) rack space. The optional rack mount Remote Control Panel (RCP)
is equipped with rack mounting angles and fits into a standard 19 inches by 1.75 inches by 3.75 inches
(483 mm x 45 mm x 150mm) rack space. The mounting angles may be removed if rack mounting is not
desired. The optional Desktop Remote Control Panel (DCP) is designed to be mounted on a control
panel desk and is fitted with rubber feet to keep it from sliding on the desktop.
INSTALLATION
9625LG Series Logo Inserters and Media Keyers Manual
Pin #
Name
1
GND
Chassis ground
2
GPO 2
General purpose output 2
3
GPO 1
General purpose output 1
4
GPO 3
General purpose output 3
5
GPI C
General purpose input Load assigned preset
6
GPO 4
General purpose output 4
7
GPI F
General purpose input Load assigned preset
8
GPI A
General purpose input Load assigned preset
9
GPI D
General purpose input Load assigned preset
10
GP+3.3V
+3.3V from general purpose interface board
11
GPI H
General purpose input Load assigned preset
12
GPI E
General purpose input Load assigned preset
13
GPI G
General purpose input Load assigned preset
14
GPI B
General purpose input Load assigned preset
15
Vext
External voltage source for GPI's
Table 2-4: GPI/O Connector Pin Definitions
Revision 4.2
Description
Page
2-5