Table of Contents
Advertisement
9625LG Series Logo Inserters and Media Keyers Manual
3.10.9. Playlist Configuration Items (Media Keyer Units Only)
The 9625LGA and HD9625LGA Media Keyers, have the ability to run playlists that insert logos and
associated audio clips. In order to set up a playlist you will need to use the Nomad™ or Overture™
software. The playlist file (EKP) is sent by Nomad™ or Overture™ to the 9625LGA Series Media
Keyer. See the Nomad™ section of the Evertz Keyer Toolkit manual or refer to the Overture™ manual
for more information on preparing playlists.
The MEDIA Setup menu has two items that are used to view the logo and audio file that will be played
when the playlist is faded in. These items are only available when you select a playlist from the front
panel. Sections 3.10.9.1 and 3.10.9.2 provide detailed information about each of the sub-menus.
3.10.9.1. Showing the Logo Name for a Playlist
MEDIA
Logo Name
LN: none
LN: Logo name
3.10.9.2. Showing the Audio Clip Name for a Playlist
MEDIA
Audio Name
AN: none
AN: Audio name
3.11 HTML Setup Page
As of firmware version 2.0, the audio setup for the 9625LGA Media Keyers is done via an HTML page.
If the firmware version installed in your unit is less than 2.0 please upgrade to the latest version which
is posted on the Evertz website. See section 6.2 for instruction on upgrading the firmware in your unit.
The HTML page also allows you to configure the unit to acquire METAR data for use with temperature
logos. You can access the HTML setup page by launching your Internet browser and entering the IP
address of the 9625SW in the address bar. The following sections provide a description of the features
available on the HTML setup page.
Page 3-32
The Logo Name menu item is used to show the logo name for the playlist.
In order to change the logo name for a playlist you will need to use the
Nomad™ or Overture™ software.
The Audio Name menu item is used to show the audio clip name for the
playlist. In order to change the audio clip name for a playlist you will need
to use the Nomad™ or Overture™ software.
Revision 4.2
OPERATION
Advertisement
Table of Contents
