Setting The Time Zone Offset; Enabling Daylight Saving Time Compensation; Selecting Whether The Time Code Input Is Utc Or Local Time - evertz 9625LG Instruction Manual

9625LG Series Logo Inserters and Media Keyers Manual
3.6.3.4.

Setting the Time Zone Offset

GENERAL
Time Setup
Zone -05:00:00
3.6.3.5.

Enabling Daylight Saving Time Compensation

GENERAL
Time Setup
DST Active
off
on
The 9625LG Series Keyer must be manually changed from Daylight Saving time to
Standard time using this menu setting. If you want to automatically keep the time
clock in the 9625LG Series Keyer in sync with the correct local time, connect a
source of linear time code that contains local time to the LTC IN connector. See
section 3.6.3.6
3.6.3.6.

Selecting Whether the Time Code input is UTC or Local Time

GENERAL
Time Setup
LTC Time Zone
Ltc zone : Local
Ltc zone : UTC
Page 3-12
This menu item allows the user to set a time zone offset between the UTC
time and the Local time. This time zone offset will be added to the UTC
time along with the Daylight Saving time correction (see section 3.6.3.5) to
obtain the Local time. Time zones are normally in one hour or 30 minute
increments and can be + or – from UTC. (Time zones east of Greenwich
are +, and time zones west of Greenwich are -)
To set the time zone press the SELECT button and the hours digits will be
flashing to indicate that they are in entry mode. Use the
change the hours to the desired value. To set negative time zone offsets
continue pressing the
negative sign. Then press the SELECT button and the minutes digits will
be flashing to indicate that they are in entry mode. Set the minutes and
seconds in the same way. When you have entered the correct time press
the SELECT button to the set the time zone offset. The seconds digits will
stop flashing to indicate that the time zone offset has been set.
This menu item allows the user to control whether Daylight Saving Time
(DST) compensation will be applied to derive the local time.
When set to off, Daylight Saving Time compensation will not be applied.
When set to on Daylight Saving Time compensation will be applied and the
local time will be adjusted back by 1 hour.
This menu item allows the user to select whether incoming time code will
be in UTC or local time. This information is necessary to correctly update
the RTC clock from the time code.
Select UTC, when the incoming LTC is Universal Co-ordinated time.
Select Local, when the incoming LTC is local time.
Revision 4.2
or buttons until the hours values show a
or buttons to
OPERATION