Example - Edwards EPX HiVac Series Instruction Manual

rr1
::J
A419-00-880 Issue K
0..
4 . 8 Example
c
V') Here is an example of how to interpret the menu diagrams. The following procedure describes how to change the
(1)
parameters displayed on the normal display.
l
1. Press the Setup button to enter the Setup menu (Figure 25).
n
0
::J
,......
l
0
-
-
( 1)
l
..-.
rr1
c
n
._.
OJ
::J
0..
-a
c
3
-o
0
-·
V')
-o
-
O J
'<
-i
(1)
l
3
-·
::J
OJ
--
..-.
-a
0
-i
._.
3
(1)
::J
c
V')
2.
3.
4.
5.
6.
7.
8.
9.
Use the up and down buttons to change the first digit of the setup password to the correct value, then press the
ENTER button.
Use the up and down buttons to change the second digit of the setup password to the correct value, then press
the ENTER button.
Use the up and down buttons to change the third digit of the setup password to the correct value, then press the
ENTER button.
If the correct password has been entered, the display will then show 'SETUP MENU' on the top line and the
software version on the bottom line. (Figure 26) .
Press the down button or the up button twice; the display will then show 'SETUP MENU' on the top line and
Normal display on the bottom line.
Press the ENTER button; the display will then show 'SELECT LINE' on the top line and 'Top Page 1' on the bottom
line (refer to Figure 28) .
Press the ENTER button; the display will then show 'SELECT PARAMETER' on the top line and the currently
selected parameter on the bottom line.
Press the up or down buttons to change the parameter displayed to the required parameter, then press the
ENTER button. The top line of the Normal Display will now display the parameter that was selected.
Page 42
© Edwards limited 2017. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards limited.