3.5
Attaching the STC-U to a rack
The STC-U cannot be supported with only the 4 screws on the front panel. Always support it from
Attach the STC-U as follows:
Note : For the dimensions of the front panel and positions of the screw holes, refer to Figure 10.
• Attach the front panel to the rack using the 4 screws. (see Figure 14 [1]).
• Support the STC-U from the bottom using a support angle or a similar tool. (Figure 14 [2])
• When attaching the STC-U to a movable rack, to protect the STC-U during transport, attach the
STC-U to the rack using the screw holes on the bottom. (see Figure 10)
1
Front panel 4 securing screws
STC-U eTMS unit
CAUTION
the bottom using a support angle.
1
2
Figure 14 - Example of securing the STC-U
2
Mounting support
3
MT-92E-A01-C
Page 17