Recover From A Power Failure; Power Instrument On And Off; Parts And Accessories - Micromeritics ACCUPYC III Operator's Manual

3 Maintenance and Troubleshooting
R F
ECOVER ROM A
If an analysis was in progress when a power failure occurred, completed cycles will be saved. The
instrument is vented on startup to ensure that it is in a safe state.
Even though the instrument saves data during a power failure, any operation should
be restarted to ensure complete results.
P I
OWER NSTRUMENT
This instrument does not have a power switch and must be disconnected from the
wall outlet when powering off; therefore it is important to position the instrument where
the wall outlet is easily accessible.
When the analyzer is powered on, after a few seconds, the system vents automatically. Allow
approximately 30 minutes for temperature stabilization before performing analyses. For analyses
that require very precise results, allow the analyzer to warm a minimum of two hours.
Wait a minimum of 30 seconds between powering off and powering on the instrument.
P A
ARTS AND CCESSORIES
Parts and accessories are located on the
3 - 64
P F
OWER AILURE
O O
N AND FF
Micromeritics web page.
AccuPyc III Operator Manual
135-42800-01 (Rev -) — Nov 2023