Recover From A Power Failure; Reset The Pycnometer - Micromeritics ACCUPYC II 1345 Operator's Manual

R F
ECOVER ROM A
Setup parameters and collected data are recorded by the pycnometer in case of a power failure.
These settings will be available when power is restored. If an automatic operation was in progress
when the power failure occurred, it will be canceled when the pycnometer restarts.
Even though the pycnometer saves data during a power failure, any operation should be
restarted to ensure complete results.
R P
ESET THE YCNOMETER
Use these instructions for keypad installations only. If a computer is attached to the
module, skip this section. All setup functions will be done in the analysis software.
There are two ways to reset the Pycnometer.
Hold the .(decimal) key on the keypad during power ON. This erases data and setup parameters
n
except for printer and network settings.
Hold 5 on keypad during power ON. This resets setup parameters, as well as printers and net-
n
work settings.
AccuPyc II 1345 Operator Manual
134-42851-01 (Rev A) — Jan 2021
P F
OWER AILURE

Recover From a Power Failure

12 - 17