Micromeritics ACCUPYC III Operator's Manual page 32

2 About the Software
O : C
PTIONAL ONNECT
There are USB ports located on both the front and back of the AccuPyc III. Mouse, keyboards,
analytical balance, Wi-Fi dongle, barcode scanner, and USB drives can be connected. If a mouse
is connected, the power must be cycled before it can be used.
O : C
PTIONAL ONNECT
There are two Ethernet connections on the back of the AccuPyc III.
The MIC NET allows the AccuPyc III to be connected to other AccuPyc IIIs as well as legacy
n
AccuPyc II instruments. Reports from the connected legacy instruments can be displayed in
the AccuPyc III Records screen.
The LAB NET connects a unit to a network. If a computer is connected to the same subnet as
n
the instrument, the unit can be controlled through a browser. Data can be exported from the
instrument and viewed within the MicroActive software.
E W -F
NABLE I I
To enable Wi-Fi capabilities, a dongle is required and can be plugged into one of the USB ports on
the back of the instrument.
1. On the touchscreen, tap
2. In the Wi-Fi field, tap and make a selection.
C B
ONNECT TO ROWSER
The AccuPyc III can be controlled through a browser. Chrome is recommended.
1. Connect an Ethernet cord to the LAB NET port on the back of the instrument. The unit will
need to be connected to a network via Ethernet in which a DHCP server can assign an IP
address to the instrument. A DHCP server located on your network will automatically assign
an IP address to the AccuPyc III.
2. On the touchscreen, tap
3. Note the IP address shown in the LAB NET field.
4. Type this address into the browser.
2 - 2
USB D
EVICE
LAB NET MIC NET
OR
Settings > Communications >
Settings > Communications.
TCP/IP.
AccuPyc III Operator Manual
135-42800-01 (Rev -) — Nov 2023