Steering Angle Sensor Removal And Installation; Steering Angle Sensor Inspection - Suzuki GRAND VITARA 2005 Service Manual

6B-4 Steering Wheel and Column:
3) Connect all connectors that have been removed in
"Removal".
4) Install steering column upper cover (2) and lower
cover (3), and then tighten steering column cover
screws (1).
CAUTION
!
When installing lower cover (3) and upper
cover (2), be careful so that each lead wire is
not caught between covers.
2
*: Standard screw
**: Tapping screw
5) Install steering column hole cover (1).
6) Install steering wheel to steering column. Refer to
"Steering Wheel Removal and Installation: in related
manual".
1**
3
1*
I5JB0A620015-01
1
I5JB0A620011-01

Steering Angle Sensor Removal and Installation

Removal
1) Remove steering wheel and contact coil cable
assembly. Refer to "Steering Wheel Removal and
Installation: in related manual" and "Contact Coil
Cable Assembly Removal and Installation: ".
2) Remove steering angle sensor (2) from contact coil
cable assembly (3) while opening fitting parts (1) of
contact coil cable assembly.
1
2
3
Installation
1) Install steering angle sensor (2) by fitting
engagement parts (1) of contact coil cable assembly
to claws of steering angle sensor as shown in figure.
1
2
2) Install contact coil cable assembly and steering
wheel. Refer to "Contact Coil Cable Assembly
Removal and Installation: " and "Steering Wheel
Removal and Installation: in related manual".

Steering Angle Sensor Inspection

Refer to "Steering Angle Sensor Inspection: in Section
4F".
S5JB0B6206014
1
I6JB01620003-01
1
I6JB01620004-01
S5JB0B6206015