Suzuki GRAND VITARA 2005 Service Manual page 474

5C-6 Clutch:
2) Using special tool, install input shaft bearing to
flywheel.
Special tool
(B): 09925–98210
3) Aligning clutch disc to flywheel center by using
special tool, install clutch cover (1) and bolts (2).
Then tighten bolts to specification.
NOTE
• While tightening clutch cover bolts,
compress clutch disc with special tool by
hand so that disc centered.
• Tighten cover bolts little by little evenly in
diagonal order.
Special tool
(A): 09924–17811
(C): 09923–36320
Tightening torque
Clutch cover bolt (b): 20 N·m (2.0 kgf-m, 14.5 lb-
ft)
I5JB0A530020-01
4) Slightly apply grease to input shaft (1).
"A": Grease 99000–25210 (SUZUKI Super
Grease I)
5) Join transmission assembly with engine.
Refer to "Manual Transmission Assembly
Dismounting and Remounting: in Section 5B".
NOTE
Turn crankshaft with wrench from front while
inserting transmission input shaft (1) to
clutch disc until splines mesh.
IYSQ01530022-01
1, "A"
IYSQ01530023-01
I5JB0A530021-01