Suzuki GRAND VITARA 2005 Service Manual page 429

Steering Angle Sensor Removal and Installation
Refer to "Steering Angle Sensor Removal and
Installation: in Section 6B".
Steering Angle Sensor Inspection
• Check sensor for dents, cracks or deformation.
• Check sensor connector (sensor side and harness
side) and sensor connector lock mechanism for
damage or crack.
• Check connector terminals for bend, corrosion or rust.
If it is found faulty, replace steering angle sensor (1).
ESP® OFF Switch Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove center garnish with audio unit (if equipped)
and HVAC control module referring to "Audio Unit
Removal and Installation: in Section 9C in related
manual".
3) Remove HVAC control module from center garnish,
referring to "HVAC Control Module Removal and
Installation: in Section 7A in related manual".
4) Remove ESP® OFF Switch (1) from center garnish
(2).
2
Installation
Reverse removal procedure.
S5JB0B4606106
S5JB0B4606107
1
I6JB01460033-01
S5JB0B4606024
1
I6JB01460034-01
Electronic Stability Program:
ESP® OFF Switch Inspection
Check for continuity between terminals at each switch
position.
If check result is not as specified, replace ESP® OFF
switch.
2
1
Terminal
ESP OFF switch
FREE
PUSH
S5JB0B4606108
1 2
I6JB01460035-02
4F-52