Suzuki GRAND VITARA 2005 Service Manual page 22

0B-3 Maintenance and Lubrication:
Engine Accessory Drive Belt, Tensioner and
Idler Replacement
WARNING
!
Replacement must be performed with battery
negative cable disconnected to avoid a
personal injury.
Replace belt (1), tensioner (2) and idlers (3) with new
ones referring to "Accessory Drive Belt and Idler Pulley
Removal and Installation: in Section 1J".
Check crankshaft pulley (4) for wear and damage, and
replace it as necessary.
3
Camshaft Timing Belt and Tensioner
Replacement
Replace camshaft timing belt (1) and tensioner (2) with
new ones referring to "Timing Belt and Belt Tensioner
Removal and Installation: in Section 1D".
Repair Instructions
S5JB0B0206002
4
1
2
I5JB0B020001-02
S5JB0B0206042
I5JB0B020002-01
Engine Oil and Filter Change
WARNING
!
• New and used engine oil can be
hazardous.
Be sure to read "General Precautions: in
Section 00" and observe what in written
there.
• Steps 1) – 7) must be performed with
ENGINE NOT RUNNING. For Step 8), be
sure to have adequate ventilation while
engine is running.
CAUTION
!
Do not top up oil over FULL level mark on
dipstick. Too much oil could destroy engine.
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall
drain plug.
Tightening torque
Engine oil drain plug (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
3) Loosen oil filter by using oil filter wrench (special
tool) accessing from between engine mounting and
radiator outlet hose and from below vehicle.
Special tool
(A): 09915–46510
(A)
S5JB0B0206004
(a)
I5JB0B020003-01
I5JB0B020004-01