Suzuki GRAND VITARA 2005 Service Manual page 9

• When performing service to electrical parts
that does not require use of battery power,
disconnect the negative cable of the
battery.
• When disconnecting the negative cable
from the battery, be careful to the
following.
– Check and record DTCs in immobilizer
control module if necessary before
disconnecting.
– Record displayed contents of the clock
and/or audio system, etc. before
disconnecting and reset it as before
after connecting.
– For vehicle equipped with power sliding
roof (sunroof), initialize sliding roof
position data in motor unit by
performing "How to reactivate the
system to prevent being pinched by the
sunroof" in Sunroof section of Owner's
manual.
• When removing the battery, be sure to
disconnect the negative cable first and
then the positive cable. When
reconnecting the battery, connect the
positive cable first and then the negative
cable, and replace the terminal cover.
• When removing parts that are to be reused,
be sure to keep them arranged in an
orderly manner so that they may be
reinstalled in the proper order and
position.
• Whenever you use oil seals, gaskets,
packing, O-rings, locking washers, split
pins, self-locking nuts, and certain other
parts as specified, be sure to use new
ones. Also, before installing new gaskets,
packing, etc., be sure to remove any
residual material from the mating surfaces.
I2RH01010026-01
• Make sure that all parts used in
reassembly are perfectly clean.
• When use of a certain type of lubricant,
bond or sealant is specified, be sure to
remove the old one thoroughly and use the
specified type.
"A": Sealant 99000–31150 (SUZUKI Bond
No.1207C)
I2RH01010027-01
Precautions: 00-2
I2RH01010028-01
I2RH01010029-01
I2RH01010030-01