PRO165SL/SLE
Figure 4-12:
Manual Feed Method
6. Manually pull the new belt back and forth through the table. Confirm that the side seal belt feeds
through smoothly without friction or snagging. If there appears to be damages preventing
successful installation, contact Aerotech Global Technical Support .
7. Apply equal tension to both loose ends of the new side seal belt to stretch the spring. With the
spring stretched, the spring and belt assembly should look like
8. While you are still holding tension in the belt, wrap the ends of the side seal belt around the front
pins as shown in
properly wrapped around the pins and there is enough spring tension.
Figure 4-13:
Belt Wrap
62
Figure
4-13. The side seal belt should hold the tension without glue if it is
Hardware Manual
Figure 4-9
at the rear of the stage.
www.aerotech.com