Table of Contents
Advertisement
Hardware Manual
DANGER: You will invalidate the alignment and could invalidate the calibration if you
unmount a stage from its mounting surface.
IMPORTANT: A minimum of two (2) people are required to tilt the stage on its side to
avoid injury to the user.
DANGER: If the stage has a brake, you will have to apply power to the stage and motor
and enable them to allow this movement. Disable and disconnect the stage electrical
power before you continue with this step.
5. (Manual Feed Method) Install the new belt through the stage table.
a. Carefully tilt the stage onto its side. Do not pinch any wires or damage any machined surfaces.
b. Manually position the stage table to provide access to the cover plate mounting screws. Refer
to
Figure
4-11.
c. Remove the cover plate.
d. Push the new side seal belt around the rollers. Refer to
e. Reinstall the cover plate and screws.
f. Repeat steps "a" through "e" on the opposite side of the stage.
Figure 4-11:
Stage Table Cover Plate Removal
www.aerotech.com
Figure
4-12.
PRO165SL/SLE
61
Advertisement
Table of Contents
