Figure 4-10: Pull Through Method - Aerotech PRO165SLE Hardware Manual

PRO165SL/SLE
There are two methods that you can use to install the new belt through the stage table:
Pull Through Method: Use this method if the old belt is intact and fed through the stage table.
Manual Feed Method: Use this method if the old belt is not fed through the stage table.
4. (Pull Through Method) Install the new belt through the stage table. Refer to
a. Make a clean, perpendicular cut on the rear portion of one side of the old side seal belt.
b. Attach the loose end of the new side seal belt to the old belt with super glue.
i. Overlap the old belt and new belt by 10 mm.
ii. The new belt should be on the inside of the old belt.
iii. Make sure there are no twists in the glued side seal belts and that the glue connection is
secure.
c. Carefully pull on the old side seal belt to thread the new side seal belt through the stage table.
d. After the new belt is pulled through the stage table, cut the off the old side seal belt from the
new belt with a perpendicular cut.
e. Repeat steps "a" through "d" on the opposite side of the stage.
Figure 4-10: Pull Through Method
60
Hardware Manual
Figure 4-10.
www.aerotech.com