Figure 4-5: Attach The Coupling Adapter To The Motor Shaft; Figure 4-6: Attach The Motor The Stage - Aerotech PRO165SLE Hardware Manual

Hardware Manual
How to Mount a Motor
1. Remove the hard cover from the stage.
2. Locate the Shaft Coupling access holes (refer to
3. Test fit the Motor and Shaft Coupling to the Stage to ensure that you have access to the Shaft
Coupling clamp screws.
4. Apply a small quantity of either Loctite 242 or Loctite 248 to motor and coupling hardware.
5. Attach the Shaft Coupling to the Motor shaft (refer to
correct hardware and torque requirements.
Figure 4-5: Attach the Coupling Adapter to the Motor Shaft
6. Attach the Motor to the Stage in the correct orientation
that the motor flange is fully seated and the hardware is tight. The motor housing prevents the
use of a torque wrench.
Figure 4-6: Attach the Motor the Stage
www.aerotech.com
Figure 4-4).
Figure 4-5). Refer to
(Figure 4-6). Use a hex wrench to ensure
PRO165SL/SLE
Table 4-1 for the
55