Table of Contents
Advertisement
Hardware Manual
9. Adjust the tension on the left and right sides. Make sure that the spring is centered and
stretched. Make sure that there is enough tension in the spring to satisfy all alignment
requirements.
10. Trim the side seal belts. Leave approximatley 50 mm of overlap for adjustments and glue.
DANGER: If the stage has a brake, you will have to apply power to the stage and motor
and enable them to allow this movement. Disable and disconnect the stage electrical
power before you continue with this step.
11. With the belts secured in place and holding tension without glue, manually move the stage table
through its full travel to confirm belt alignment.
a. The side seal belt must run parallel to the direction of travel and the belt must ride within its
channel to avoid damaging the belt. Refer to
b. Adjust the tension and placement of the new side seal belt until it is correctly aligned.
Figure 4-14:
www.aerotech.com
Belt Alignment
Figure
4-14.
PRO165SL/SLE
63
Advertisement
Table of Contents
