Figure 4-8: Belt Removal At The Attachment Pins - Aerotech PRO165SLE Hardware Manual

PRO165SL/SLE
Replacement Procedure:
1. Remove the hardcover. Clean and lubricate the stage (optional but recommended).
a. Refer to Section 4.2.
b. DO NOT replace hardcover or rear end plate after you clean and lubricate the stage.
IMPORTANT: Inspect the stage for any damage that could have caused the old side seal
belts to need replacement. Do not continue with this procedure if there are signs of
damage. Contact Aerotech Global Technical Support for assistance.
2. Remove the old side seal belt.
a. DO NOT pull the belt out of the stage table if the belt is intact.
b. Note which side of the stage holds the tension spring, this will be referred to as the rear of the
stage.
c. Pull the belt up at the attachment pins
Figure 4-8: Belt Removal at the Attachment Pins
58
(Figure 4-8).
Hardware Manual
www.aerotech.com