PRO165SL/SLE
12. Once the belt is fully adjusted, trim the ends of the belt as shown in
Figure 4-15:
13. Create a permanent loop on both ends of the side seal belt by applying a small amount of super
glue (cyanoacrylate glue) to the overlapping end tabs. The belt can be removed from the pins to
avoid getting excess glue on stage components.
14. Reinstall the hardcover and rear end plate. Refer to
15. With the stage fully reassembled, do a final test of the belt alignment. Move the stage through full
travel to observe if there is interference with the hardcover. Repeat installation steps as needed
to improve belt alignment.
64
Belt Trim
Figure
4-15.
Section 4.2.
Hardware Manual
www.aerotech.com