Table of Contents
Advertisement
For the 1732E-OB8M8SR, you can do the following
through the Configuration tab:
1. Set the Output State during Program Mode and Fault
Mode for Points 0...7.
2. Set the Fault Duration and Fault Final State for Points
0...7.
Grayed out unless Hold Duration is something other
than "Forever".
3. Click OK to close the Module Properties dialog and
download your configuration, or
4. Click Help to access the Studio 5000 Logix Designer
software Add-On Profile help for descriptions of tabs
that are not required for setting up your module.
For more information on Output States, see Configurable
Point-Level Output Fault States on
Download Your
Configuration
1. Click here to see the pull-
down menu.
2. Click download.
Edit Your Configuration
Figure 10 - 1732E-OB8M8SR Configuration Tab
page
56.
After you write configuration for your module, the module does not use this
configuration until you download it to the owner-controller. The download
transfers the entire program to the controller, overwriting any existing
program.
Download module configuration as shown:
Depending on your application, a variety of Studio 5000 Logix Designer
software screens may appear to choose a path to your ControlLogix controller
and to verify the download. Navigate those screens as best fits your
application.
This completes the download process.
After you have set configuration for a module, you can review and change your
choices. You can change configuration data and download it to the controller
while online. This is called dynamic reconfiguration.
Your freedom to change some configurable features, though, depends on
whether the controller is in Remote Run Mode or Program Mode.
IMPORTANT Although you can change configuration while online, you must go offline to
add or delete modules from the project.
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021
Chapter 6
Configure the Module Using Studio 5000 Logix Designer Software
43
Advertisement
Table of Contents
