Table of Contents
Advertisement
Chapter 4
Install Your Module
Mount the Module
Functional Earth
Grounds the I/O block EtherNet/IP
communication circuitry which is
designed to mitigate the effect of noise
on the network. It requires a solid
earth ground connection, either
through a metal screw to a grounded
metal panel or through a wire.
22
To mount the module on a wall or panel, use the screw holes provided in the
module. Refer to the drilling dimensions illustration to guide you in mounting
the module.
179 (7.05)
43.3 (1.70)
32 (1.26 )
Install the mounting base as follows:
1. Lay out the required points as shown above in the drilling dimension
drawing.
2. Drill the necessary holes for #6 (M3) pan head screws.
3. Mount the module using #6 (M3) screws.
Mount the Module in High Vibration Areas
If you mount the module in an area that is subject to shock or vibration, we
recommend you use a flat and a lock washer to mount the module. Mount the
flat and the lock washer as shown in
screws to 0.68 N•m (6 lb•in).
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021
37 (1.46)
16.2 (0.64)
168.6 (6.64)
18 (0.71)
Front Mounting
Figure 1 on page
Millimeters
19.8
(Inches)
(0.78)
166.5 (6.56)
27 (1.06)
Side Mounting
23. Torque the mounting
Advertisement
Table of Contents
