Introduction; Set Up The Hardware - Rockwell Automation Allen-Bradley ArmorBlock 1732E-IB8M8SOER User Manual

Introduction

Set Up the Hardware

Configure the Module Using Studio 5000 Logix
Designer Software
This chapter guides you through the steps required to configure your
ArmorBlock EtherNet/IP Dual Port 8-point Sequence of Events Input and
Scheduled Output Modules using the Studio 5000 Logix Designer software.
Note that the modules presented in this chapter are configured using Studio
5000 Logix Designer software, version 18 or later.
Topic
Set Up the Hardware
Create an Example Application
Configure Your I/O Module
Overview of the Configuration Process in Studio 5000 Logix Designer
Add a New Bridge and Module to Your Project
Use the Default Configuration
Change the Default Configuration
Download Your Configuration
Edit Your Configuration
Access Module Data in Studio 5000 Logix Designer Software
Configure Studio 5000 Logix Designer and the 1756-EN2T Communication
Module for CIP Sync
The configuration of the two modules through the Studio 5000 Logix Designer
software involve the same procedure. Note, however, that the two modules
have different Module Definition properties and Configuration tabs. Both are
distinctly covered in this chapter.
In this example, a ControlLogix chassis contains the Logix 5565 processor in
slot 1 and a 1756-EN2T bridge module in slot 3. The ArmorBlock module is
mounted remotely.
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021
Chapter
Page
35
36
37
37
37
41
41
43
43
45
45
6
35