Chapter 6
Configure the Module Using Studio 5000 Logix Designer Software
If you are not offline, use this pull-
down menu to go offline.
1. Right-click I/O Configuration.
2. Select New Module.
1. Select the 1756-EN2T
2. Click OK.
38
Add the Local EtherNet/IP Bridge to the I/O Configuration
1. If necessary, go offline.
2. Add the EtherNet/IP Bridge to your Studio 5000 Logix Designer project.
3. Expand Communications and select the new module in the Select
Module dialog that appears. Select the 1756-EN2T EtherNet/IP Bridge.
EtherNet/IP Bridge.
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021