Table of Contents
Advertisement
Chapter 4
Install Your Module
24
Ethernet Connectors
See the pinout diagram in
Figure 4 - D-Code Micro Network Female Connector
4
3
1
2
5
IMPORTANT Use the 1585D–M4DC–H: Polyamide small body unshielded mating
connectors for the D-Code M12 female network connector.
Note that the distance between the center of each Ethernet connector is
16.2 mm (see dimensions on page 22). Rockwell Automation recommends
the use of suitable cable based on this measurement. Some of the
recommended cables are 1585D-M4TBJM-x and 1585D-M4TBDM-x for
daisychains.
IMPORTANT Use two twisted pair CAT5E UTP or STP cable.
ATTENTION: Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP enclosure type
requirements.
Power Connectors
Attach the mini-style 4-pin connector to the mini-style 4-pin receptacle as
shown in
Figure
5.
Figure 5 - Micro-style 4-Pin Input Male Receptacle
Male Input
2
1
3
4
IMPORTANT The maximum current that any pin on the power connectors can carry is
4 A.
The power required by the module is based on a 4-pin micro-style connector
system. The module receives its required power through the male connector on
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021
Figure 4
for the network connectors.
(View into connector)
Pin 1Tx+
Pin 2 Rx+
Pin 3 Tx-
Pin 4 Rx-
Pin 5 Shell
D-Code
Wire Color
M12 Pin
1
White-Orange
2
White-Green
3
Orange
4
Green
Female Output
(View into receptacle)
Pin 1 Auxiliary power+
Pin 2 Module power+
Pin 3 Module power-
Pin 4 Auxiliary power-
8-way Modular
Signal
RJ45 Pin
TX+
1
RX+
3
TX-
2
RX-
6
2
3
1
4
Advertisement
Table of Contents
