Rockwell Automation Allen-Bradley ArmorBlock 1732E-IB8M8SOER User Manual page 42

Chapter 6 Configure the Module Using Studio 5000 Logix Designer Software
From the Connection tab, you can:
1. Change the RPI.
2. Inhibit the module. For more information on
Module Inhibiting, see
3. Make sure a Major Fault occurs on the module's
owner-controller if there is a connection failure
between the module and the controller.
4. Click the Configuration tab to go to the next
screen, or
5. Click OK to close the Module Properties dialog and
download your configuration.
For the 1732E-IB8M8SOER module, you can do the
following through the Configuration tab:
1. Set the Input Filter Times. For more information on
Input Filters, see
2. Enable Timestamp Capture for all input points or
for specific points. For more information on
Timestamp Capture, see
3. Click the box Latch Timestamps to enable
Timestamp Latching. For more information, see
page
4. Click the box to Sync to Master. The feature is not
enabled by default.
5. Click OK to close the Module Properties dialog and
download your configuration.
6. Click Help to access the Studio 5000 Logix
Designer software Add-On Profile help for
descriptions of tabs that are not required for
setting up your module.
42
page 49.
The next tab available in the Module Properties dialog is the Configuration tab.
Note that the 1732E-IB8M8SOER and 1732E-OB8M8SR modules do not have
the same Configuration tabs.
Configuration tabs of each.
Figure 9 - 1732E-IB8M8SOER Configuration Tab
page 52
page 52.
52.
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021
Figure 9 and Figure 10 guide you through the