Chapter 6
Configure the Module Using Studio 5000 Logix Designer Software
1. Name the module.
2. Enter theIP address of the module as shown.
3. Make sure the Module Definition information
matches this example.
4. Click Change... to edit the Module Definition for
your module before downloading the program to
the controller.
5. Click OK to accept the default configuration.
On the General tab, the 1732E-OB8M8SR module does not
have a Connection Format field and has an Enable MAOC
Support field under the Module Definition section.
40
3. The New Module dialog appears.
Fill in the Module Properties information as shown, and then click OK.
Module Properties Values
Field Name
Name
IP address
Electronic keying
Connection format
Revision
Timestamp
You can either accept or change the default configuration as shown.
1732E-IB8M8SOER
1732E-OB8M8SR
Rockwell Automation Publication 1732E-UM003D-EN-E - November 2021
Value
TEST_1732EIB8M8SOER or TEST_1732EOB8M8SR
192.168.1.20
Compatible Module
Data.This field does not exist for the 1732E-OB8M8SR module.
1.1
Per Point