Data Monitoring; Set Alarm Server - HIKVISION DS-2DE5425IWG-4G User Manual

Note
The default IP of the device AP is 192.168.8.1.
Result
The connected devices will be displayed in the Connected Device interface from Configuration →
Network → Advanced Settings → WLAN AP .

9.21 Data Monitoring

You can view and manage the SIM card data or wired network data used by the device. SIM card
data is the data service provided by network carriers; wired network data is usually provided
through a 4G router.
Steps
1. Go to Configuration → Network → Network Settings → Data Monitoring .
2. Check Enable.
3. Set the following parameters according to your data plan.
Plan Type
Daily, Monthly, or Annually can be selected.
Data Plan
Enter the amount of usable data and select the unit.
Pre-Alarm Threshold
When the used data reaches the set percentage of data plan, the device sends an alarm
message, and shows notification on the OSD or pop-up window.
4. Select Normal Linkage.
If Send Email or Notify Surveillance Center is selected, the device sends an alarm message by
Email or to surveillance center when the used data reaches the threshold.
5. Click Save.
Note
The function varies with different device models.

9.22 Set Alarm Server

Steps
1. Go to Configuration → Event → Alarm Setting → Alarm Server .
2. Enter Destination IP or Host Name, URL, and Port.
3. Select Protocol.
Network Speed Dome User Manual
81