Table of Contents
Advertisement
3.10 Set Power Off Memory
This function can resume the previous PTZ status of device after it restarting from a power-off.
Steps
1. Go to Configuration → PTZ → Basic Settings .
2. Select Resume Time Point. When the device stays at one position for the set resume time point
or more, the position is saved as a momory point. The device returns to the last memory point
when it restarts.
3. Click Save.
3.11 Set PTZ Priority
The function can set the PTZ priority of different signals.
Steps
1. Go to Configuration → PTZ → Prioritize PTZ .
2. Set the priority signal and delayed time.
Network
The network signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
Delay
It refers to the time interval of PTZ operation controlled by different signals. When the
operation with high priority is finished, the low priority signal controls the device after the
setting interval.
3. Click Save.
Network Speed Dome User Manual
15
Advertisement
Table of Contents
