Table of Contents
Advertisement
10. Set linkage method. See Linkage Method Settings .
7.2.4 Set Line Crossing Detection
Line crossing detection is used to detect the object movement of crossing a predefined line. When
it occurs, the device takes linkage actions as response.
Before You Start
Go to VCA → Select Application to select Smart Event, and click Next to enable the function.
Steps
1. Go to VCA → Set Application → Smart Event → Line Crossing Detection .
2. Check Enable.
3. Optional: Click Lock to lock PTZ control to prevent the interruption from other PTZ related action
during configuration.
Normally, the PTZ control is automatically locked when you enter the configuration interface.
You can manually resume the lock when the countdown is over.
4. Adjust the live image to the desired scene by using PTZ control buttons.
5. Draw detection line.
1) Select a Line No.. Up to 4 lines can be set in the scene.
2) Click
.
A yellow line is displayed on live image.
3) Click on the line, and drag its end points to adjust the length and position.
4) Select the Direction for the detection line.
Direction
It stands for the direction from which the object goes across the line.
A<->B
The object going across the line from both directions can be detected and alarms are
triggered.
A->B
Only the object crossing the configured line from side A to side B can be detected.
B->A
Only the object crossing the configured line from side B to side A can be detected.
Network Speed Dome User Manual
53
Advertisement
Table of Contents
