Table of Contents
Advertisement
4. Click Dial Plan. See Set Arming Schedule for detailed information.
5. Click Dial Status.
Click Refresh
Click Disconnect Disconnect the 3G/4G wireless network.
When the Dial Status turns to Connected, it means a successful dial.
6. Access the device via the IP Address of the computer in the network.
- Input the IP address in the browser to access the device.
- Add the device in client application. Select IP/Domain, and input IP address and other
parameters to access the device.
9.20 WLAN AP (Access Point)
The device can be used as a wireless access point with the WLAN AP function. You can connect
your phone or PC to the device AP, so as to access to the device and configure the parameters via
your phone or PC.
Note
The function is only supported by certain device models.
9.20.1 Set WLAN AP
Steps
1. Go to Configuration → Network → Advanced Settings → WLAN AP .
2. Select the WLAN AP mode.
On
The function is enabled.
Maintenance Mode
The WLAN AP function is automatically turned on for 5 minutes after the device is cold
booted (by turning the switch on the device to ON), after which the WLAN AP function is
turned off if the device's 4G communication is normal, and remains on if the device's 4G
communication is abnormal.
Off
The function is disabled.
3. Set the related parameters.
SSID
The default SSID of the device is named as "Hik-Serial Number". You can define it as needed.
Security Mode
WPA2-personal mode is supported.
Network Speed Dome User Manual
Refresh the dial status.
79
Advertisement
Table of Contents
