Table of Contents
Advertisement
Note
Recording stops when the space for pattern scan is 0%.
5. Click
to complete one pattern scan path settings.
6. Click
to call pattern scan.
Stop pattern scan.
Reset pattern scan path.
Delete the selected pattern scan.
Note
If you need to delete all the pattern scans, go to Configuration → PTZ → Clear Config , and
check Clear All Patterns, and click Save.
3.5 Set Limit
The device can only move within the limited range.
Steps
1. Go to Configuration → PTZ → Limit .
2. Check Enable.
3. Select Limit Type.
Manual Stops
It refers to the movement range limit when you control the device manually.
Scan Stops
It refers to the movement range limit when the device scans automatically.
Note
Scan limit is only supported by the device that has scan function.
4. Click Set and set limits according to the prompt on the live image.
5. Optional: Click Clear to clear the limit settings of the selected mode.
6. Click Save.
Note
If you need to cancel all the set patrol paths, go to Configuration → PTZ → Clear Config , select
Clear All PTZ Limited, and click Save.
Result
The device can only move within the set region after saving the settings.
Network Speed Dome User Manual
12
Advertisement
Table of Contents
