Table of Contents
Advertisement
Steps
1. Go to NAS setting page: Configuration → Storage → Storage Management → Net HDD .
2. Click Add.
3. Set Mounting Type.
Mounting Type
Select file system protocol according to the operation system.
Enter user name and password of the net HDD to guarantee the security if SMB/CIFS is
selected.
4. Set the Server Address and File Path for the disk.
Server Address
The IP address of the network disk.
File Path
The saving path of network disk files.
5. Click Test to check whether the network disk is available.
6. Click OK to finish the steps to add a Net HDD.
7. Optional: Configure the Net HDD.
Edit
Click
Delete Delete the Net HDD.
Click
●
Select the Net HDD, click Delete.
●
8. Click Save.
6.1.4 eMMC Protection
It is to automatically stop the use of eMMC as a storage media when its health status is poor.
Note
The eMMC protection is only supported by certain device models with an eMMC hardware.
Go to Configuration → System → System Settings → System Service for the settings.
eMMC, short for embedded multimedia card, is an embedded non-volatile memory system. It is
able to store the captured images or videos of the device.
The device monitors the eMMC health status and turns off the eMMC when its status is poor.
Otherwise, using a worn-out eMMC may lead to device boot failure.
6.1.5 Set Cloud Storage
It helps to upload the captured pictures and data to the cloud. The platform requests picture
directly from the cloud for picture and analysis. The function is only supported by certain models.
Network Speed Dome User Manual
to edit the parameter setting.
.
39
Advertisement
Table of Contents
