Table of Contents
Advertisement
OPERATION
6
I
S Electr: Power
Failure
I
I Electr.
Operation Info
1 Error message for pipe 1 and pipe 2 configuration
152
Tot 1 Power Failure
Tot 2 Power Failure
Tot 3 Power Failure
Power Failure Detected
Zero Calibr. Running
1
Sensor Starting up
Tot 1 Stopped
Tot 2 Stopped
Tot 3 Stopped
Control In A Active
Control In B Active
Status Out A Active
Status Out B Active
Status Out C Active
Status Out D Active
Disp. 1 Overrange
Disp. 2 Overrange
Optical Interf. Active
www.process.honeywell.com
VERSAFLOW SONIC 1000/TWS 9000
Power failure has occurred.
The totaliser state may be
invalid.
A zero calibration in
progress
Sensor starts up. This is
normal operation at the
beginning of measuring
mode. Other error
messages are suppressed.
Totaliser 1 was stopped.
Totaliser 2 was stopped
Totaliser 3 was stopped
The value in the 1st
measurement line of the
display page is limited
The value in the 2nd
measurement line of the
display page is limited
The optical interface is being
used. The optical keys are
deactivated.
Check the value of the
totaliser.
Wait until finished
After some moments, the
converter will act and
respond with the converter
status.
If totaliser is to continue
counting, select "Yes" in
Fct. C5.y.9 (Start Totaliser).
for y = 1; 2; 3:
1 = totaliser 1; 2 = totaliser
2; 3 = totaliser 3
Check setting for 1st
measurement line
Check setting for 2nd
measurement line
The keys are ready for
operation again
approximately 60 seconds
after the end of the data
transfer/removal of the
optical interface
34-VF-25-07 iss.2 GLO Nov 11 US
Advertisement
Table of Contents
