Table of Contents
Advertisement
2. (Optional) Install hardware options. For installation instructions, see Hardware options installation on page 55.
Rack the server
3. Install the server in a rack.
4. Decide how to manage the server:
•
Locally: use a KVM switch or a connect a keyboard, monitor, and mouse.
•
Remotely: connect to the iLO web interface and run a remote console:
a. Verify the following:
◦
iLO is licensed to use the remote console feature.
If iLO is not licensed, visit the HPE website:
http://www.hpe.com/info/ilo
◦
The iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
◦
The iLO hostname is located on the serial number/iLO information pull tab.
◦
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
◦
If a static IP address is assigned, use that IP address.
◦
The default login credentials are located on the serial label pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
Power on the server
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
Update the firmware
6. Using the SPP, update the following:
•
System ROM
•
Storage controller
•
Network adapters
•
Intelligent Provisioning
Set up storage
7. Set up the storage. Do one of the following:
•
To configure the server to boot from a SAN, see the following guide:
https://www.hpe.com/info/boot-from-san-config-guide
•
If an HPE Smart Array SR controller is installed, use HPE Smart Storage Administrator to create arrays:
46
Setup
Advertisement
Table of Contents
