Table of Contents
Advertisement
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Install the access panel.
2. Install the server into the rack.
3. Connect all peripheral cables to the server.
4. Connect each power cord to the server.
5. Connect each power cord to the power source.
6. Power up the server.
7. If removing the riser blank from primary riser, remove the primary riser cage.
8. Remove the riser blank.
•
Primary riser slot 1
•
Primary riser slot 2
Operations
37
Advertisement
Table of Contents
