Table of Contents
Advertisement
Installing the intrusion detection switch
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5.
Remove the access panel.
6.
Install the intrusion detection switch.
7.
Install the access panel.
8.
Install the server into the rack.
9.
Connect all peripheral cables to the server.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
The installation is complete.
86
Hardware options installation
Advertisement
Table of Contents
