Vibration; Manual/Automatic Vibration; Manual Vibration - Switching On - Fayat Group DYNAPAC CA5000 Instruction Manual

Display symbol Display symbol
1
3
Fig. Control panel
1. Automatic vibration control (AVC)
2. Switch, vibration On/Off
3. Rpm switch
4. Working mode
Fig. F/R lever
1. Vibration ON/OFF
2019-10-01
Sound Sound Soot Soot
level level
>214% >214%

Vibration

Manual/Automatic vibration

4 Activate the button for the Working mode (4).
Manual or automatic vibration activation/deactivation is
selected using button (1).
2
In the manual position, the operator activates vibration
using the switch (2) on the forward/reverse lever.
In automatic mode (AVC), vibration is activated when
the speed is ≥ 1.5 km/h (0.9 mph) and turns off at a
speed of 1.2 km/h (0.75 mph)
Activation of vibration for the first time, as well as
disconnection of automatic vibration, are performed
with the switch (2) on the forward/reverse lever.
Note that vibration can only be activated when the
working mode (4) is activated, and when the speed
selector (3) for the engine is in high (HI) or Eco
mode (ECO). After 10 seconds in neutral, the
vibration is switched off and the machine drops to
low speed.

Manual vibration - Switching on

1
Engage and disengage vibration using the switch (1)
on the front of the forward/reverse lever.
Always switch off vibration before the roller comes to a
standstill.
4812158701_G.pdf
Comment Comment
"Red warning" flashes on the panel. The "Red warning" flashes on the panel. The
engine's output is reduced by 30% and max. engine's output is reduced by 30% and max.
1200 rpm. 1200 rpm.
DEUTZ service must be contacted DEUTZ service must be contacted
Burnout not possible, as DPF must be Burnout not possible, as DPF must be
replaced. replaced.
Never activate vibration when the roller is Never activate vibration when the roller is
stationary. This can damage both the surface and stationary. This can damage both the surface and
the machine. the machine.
Operation
"Yellow "Yellow
warning" warning"
1Hz 1Hz
73