Vibration; Manual/Automatic Vibration; Manual Vibration - Switching On - Fayat Group DYNAPAC CC224C Instruction Manual

1
2
3
Fig. Control panel
1. Automatic vibration control (AVC)
2. Switch, vibration On/Off
3. Rpm switch
4. Working mode
Fig. F/R lever
1. Vibration ON/OFF
74

Vibration

Manual/Automatic vibration

4
Activate the button for the Working mode (4).
Manual or automatic vibration activation/deactivation is
selected using button (1).
In the manual position the operator has to activate the
vibration via the bottom left switch on the
forward/reverse lever (2).
In automatic mode (AVC), vibration is activated when
the speed is ≥ x km/h (... mph) and turns off at a speed
of x km/h (...mph)
Activation of vibration for the first time, as well as
disconnection of automatic vibration, are performed
with the switch (2) on the forward/reverse lever.
Note that vibration can only be activated when the
working mode (4) is activated, and when the Rpm
switch (3) for the engine is in high (HI) or Eco
mode (ECO). After 10 seconds in neutral, the
vibration is switched off and the machine drops to
low speed.

Manual vibration - Switching on

1
Engage and disengage vibration using the switch (1)
on the front of the forward/reverse lever.
Always switch off vibration before the roller comes to a
standstill.
When compacting thin layers of asphalt up to approx.
50 mm (2 inches) thick, the best results are achived
with low amplitude/high frequency.
4812159701_D.pdf
Never activate vibration when the roller is Never activate vibration when the roller is
stationary. This can damage both the surface and stationary. This can damage both the surface and
the machine. the machine.
Operation
2021-03-16