Connecting The Fiber Optic Cable To The Projector Through The Straight Strain Relief - Christie Mirage SST Installation And Setup Manual

10. To lock the fiber in place, rotate the locking collar clockwise until you see the locking pin start
to turn and no longer moves forward and then rotate the knurled ring clockwise.
11. Attach the strain relief to the projector and tighten the two screws to secure it.
12. Wrap the fiber optic cable inside the protective pad and position in the groove.
13. To install the back portion of the clamp over the fiber optic cable and tighten the four screws
removed in step 4.
Connecting the fiber optic cable to the projector through the
straight strain relief
Attach the fiber optic cables from the laser illumination source to the projector using a straight strain
relief.
For additional information on the laser illumination source and the fiber optic cable, refer to the laser
illumination source's product documentation.
1. Remove the curved portion of the strain relief.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
35