Turning On The System - Christie Mirage SST Installation And Setup Manual

• Local operation— On the laser illumination source, press the green Start button (D). This
illuminates the green (button) light and the yellow light goes out.
• Remote operation—From the automation device, turn on the lasers with a 500ms contact
closure of circuits 21/22 on the J33 wire. This illuminates the green (button) light and the
yellow light goes out.
The two Emission status indicators (E) turn red. When the lasers are warmed up and the
projector is ready, the shutter automatically opens and you can display an image (use test
pattern if no source image is connected).
On the projector, the Status > Laser Info > Laser Bank State menu displays the message
"Warming Up". When that message disappears, the lasers are ready. It typically takes the
lasers approximately 10 to 15 minutes to warm up when turning on the first time from the off
position. This could be longer if the start-up temperatures are approaching minimum or
maximum temperatures for operation. The projector will operate with the shutter closed until
the lasers are warmed up.

Turning on the system

After the system has been initiated for the first time, not all steps need to be performed when
subsequently turning on the system.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
Never run the laser illumination source without the cooling system already running. The chiller must
be the first item turned on before power is applied to the laser rack and kept operating until after the
AC lockout/switch is rotated to the off position.
1. Check the coolant level and if the coolant level is low, check for leaks.
It is expected to see periodic evaporation of the fluid in the system. Do one of the following:
• If no leak exists, only add distilled water (not drinking water).
• If a leak exists, after the leak is repaired, add premixed coolant at the recommended 2:1
ratio.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
42