Christie Mirage SST Installation And Setup Manual page 41

• Remote operation—Rotate the main AC lockout/switch (A) to the ON position and rotate
the Power key (B) counter clockwise to the REM (remote) position. From the automation
device, turn on the laser illumination source (by closing circuits 8/9 from the J33 wire).
The Interlock status indicator (C) on the laser illumination source turns yellow.
8. On the projector beside the AC inlet, move the AC breaker/switch to the ON position.
The projector boots into standby mode after approximately 30 seconds. If the projector is
properly connected, the light on the back of the projector should be yellow.
9. Once the projector is in standby, on the projector keypad or the projector remote, press and
hold the power
The projector can also be turned on using the web user interface. After a few seconds, the
projector moves to the on state, causing the yellow light on the laser illumination source to
turn off. The laser is ready to be turned on but no illumination occurs until the green button is
pressed and the lasers have warmed up.
10. Turn on the lasers:
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
button until you hear a beep.
Installation and setup
41