Performing Initial System Start-Up - Christie Mirage SST Installation And Setup Manual

4. Make sure a qualified electrician connects the AC power to the chiller.
For electrical rating information, refer to the license label on the chiller. Additional information
is available in the chiller's product documentation.

Performing initial system start-up

Learn how to turn on all components of the Mirage SST system for the first time: chiller, laser
illumination source, and projector head.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
Never run the laser illumination source without the cooling system already running. The chiller must
be the first item turned on before power is applied to the laser rack and kept operating until after the
AC lockout/switch is rotated to the off position.
1. Verify the coolant lines are connected correctly.
2. Fill the chiller reservoir with an approved coolant.
3. Turn on the chiller, set the temperature to between 19°C (66°F) to 22°C (71.6°F).
For more information on how to turn on the chiller, refer to the chiller's product
documentation.
4. Check that no leaks exist in the system.
5. Check the coolant level in the reservoir and hoses and top up the coolant as required.
6. Allow the chiller to run until the system is operating with no new bubbles entering the
reservoir. Add additional coolant as necessary.
This typically takes approximately 5 to 10 minutes.
7. Power on the laser illumination source:
• Local operation— Rotate the main AC lockout/switch (A) to the ON position and rotate the
Power key (B) clockwise to the ON position.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
40