Connecting The Ethernet Cable To The Projector - Christie Mirage SST Installation And Setup Manual

10. Insert the fiber optic cable into the fiber input ensuring the red dots line up.
11. To lock in place, turn the locking collar clockwise until you see the locking pin start to turn and
no longer moves forward.
12. Attach the strain relief to the projector and tighten the two captive screws to secure it.
13. Wrap the fiber optic cable inside the protective pad and position in the groove.
14. Install the back portion of the clamp over the fiber optic cable and tighten the four screws
removed in step 5.

Connecting the Ethernet cable to the projector

Connect the projector to the laser illumination source with an Ethernet cable.
1. Connect one end of an Ethernet cable to the Laser Rack network port on the IMXB of the
projector.
2. Connect the other end of the Ethernet cable to the network port on the lower-left rear side of
the laser illumination source.
Mirage SST Installation and Setup Guide
020-102956-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
34