Communicating With Gs Series 599; Connecting To The Projector Rs232 In Port; Connecting To The Projector Ethernet Port; Rs232 Communication Parameters - Christie 599 GS Series Technical Reference

Communicating with GS
Series 599
Understand the information and procedures for communicating with GS Series 599 from a remote
location.
You can communicate with the projector through the RS232 IN port or the Ethernet port. When
connecting the projector to a computer, use a direct connection. Docking ports can cause software
upgrade failures.

Connecting to the projector RS232 IN port

Communicate with the projector through the RS232 IN port.
1. Connect one end of a null standard nine-pin female to female modem cable to the projector
RS232 IN port.
2. Connect the other end of the null standard nine-pin female to female modem cable to a
computer.
3. Connect PIN 2 to PIN 3, PIN 3 to PIN 2 and PIN 5 to PIN 5.

Connecting to the projector Ethernet port

Communicate with the projector through the Ethernet port.
1. Connect an Ethernet cable to the projector from your computer.
2. Setup the correct IP for the projector on your computer.
3. On the TCP software, use port 3002.
4. Start sending serial commands.

RS232 communication parameters

The RS232 IN port has several communication parameters.
Parameter
Default baud rate
Parity
GS Series 599 Serial Commands Technical Reference
020-102403-02 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Value
115200
None
7