Christie Mirage SST Installation And Setup Manual page 34

5. Discard the dummy rod located inside the protective pad.
6. Feed the fiber optic cable with the fiber connector dust cap attached on the tip through the
strain relief.
7. Remove the dust cap from the end of the fiber optic cable and store it in the safety cover.
8. To secure the fiber connector dust cap inside the safety cover, tighten the screw.
9. Gently slide the fiber optic cable into the fiber input ensuring the red dots line up.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
34