Christie Mirage SST Installation And Setup Manual page 31

The fiber connector safety cover (safety cover) must be tethered to the fiber optic cable and then
placed over the fiber connector and its dust cap. The safety cover and dust cap should be removed
only when you are ready to connect the fiber optic cable to the projector.
When handling the fiber optic cable, the minimum bend radius allowed is 150 mm.
1. Slide a cable tie through the eye of the wire lanyard and loop the cable tie loosely around the
fiber optic cable.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
Legend
A Fiber connector safety cover
B Captive screw
C Cover lid
D Wire lanyard
E Eye of wire lanyard
31