Table of Contents
Advertisement
The tethered safety cover must remain installed on the fiber connector whenever the fiber
optic cable is not connected to the projector.
When the fiber optic cable is connected to the projector, store the fiber connector dust cap
inside the tethered safety cover.
Connecting the fiber optic cable to the projector
Attach the fiber optic cables from the laser illumination source to the projector using a curved strain
relief.
For additional information on the laser illumination source and the fiber optic cable, refer to the laser
illumination source's product documentation.
1. Locate the fiber strain relief (shipped in a separate box with the projector).
2. Remove the three screws along the top of the rear lower cover.
3. Loosen the nine screws and remove the rear lower cover.
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
40
Advertisement
Table of Contents
