Table of Contents
Advertisement
15 Decommissioning
15.3
Disassembling the Inverter
Risk of injury due to the weight of the inverter
Injuries may result if the inverter is lifted incorrectly or dropped while being transported or when mounting it to the
wall mounting bracket.
• Transport and lift the inverter carefully. In doing so, keep in mind the weight of the inverter.
• Wear suitable personal protective equipment for all work on the product.
• Transport the inverter using the carrying handles or hoist. In doing so, keep in mind the weight of the inverter.
• Use all carrying handles provided during transport with carrying handles.
• Do not use the carrying handles as attachment points for hoist equipment (e.g. straps, ropes, chains). Insert eye
bolts into threads provided on top of the inverter to attach the hoist system.
To decommission the inverter completely upon completion of its service life, disassemble the inverter as described in the
following.
Requirements:
☐ All connections of the inverter are disconnected.
☐ Original packaging or packaging suitable for the weight and dimensions of the inverter is available.
☐ A pallet is available.
☐ Mounting material for attaching the packaging on the pallet is available (e.g. tie-down straps).
☐ All transport handles are in place.
Procedure:
1. Screw the transport handles as far as they will go into the tapped
holes on the right- and left-hand side until they lie flush with the
enclosure. When doing so, ensure that the transport handles are
screwed into the tapped holes so that they are perfectly straight. If
the transport handles are not screwed in straight, this can make it
more difficult or even impossible to unscrew them later on. The
tapped holes may get damaged, thus making it difficult to mount
the transport handles again.
2. Insert a screwdriver into the holes in the transport handle and turn
the screwdriver through 90°. This ensures that the transport
handles are securely tightened.
3. If the product should be lifted from the mounting bracket with the help of a hoist, screw the eye bolts into the
threads on the top of the product and attach the hoist to them. The hoist must be suitable for the weight of the
product.
174
ESSX-20-SH-en-10
CAUTION
SMA Solar Technology AG
4x
4x
90°
System Manual
Advertisement
Table of Contents
