Extron electronics FOX 4G Matrix 3200 User Manual page 82

Programmer's Guide, cont'd
Command/response Table for SIS Commands (continued)
Command
Output re-clocking
Set output re-clocker
Example:
Read re-clocker status
Save, recall, and directly write presets
N • If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
• The following characters are invalid in preset names: + - , ` @ = [ ] { } ' " ; : | \ and ?.
Save current configuration
as a global preset
Example:
Recall a global preset
Example:
Direct write process for a global preset —
N The direct write of a global preset should always be preceded by a clear global preset ties command of that same
preset number, as shown below. In a directly-written preset, each output position's tied input (or no tied input) remains
unchanged unless overwritten or cleared.
If you do not clear the ties in a global preset number before you directly write a global preset to that number, ties that
are part of the previous version of the specified preset with the same number can unexpectedly become part of the newly-
created preset.
Clear a global preset's ties
Directly write a global preset
Example:
X@
N = Input number
X#
= Output number
X%
= Output re-clocking rate
X&
= Global preset #
4-10 FOX 4G Matrix Switchers • Programmer's Guide
ASCII command
(host to switcher)
X# X%
* =
8*00=
X#
=
X& ,
,
9
X& .
.
5
E X& }
+ P0*!
E X& X@ X# X@ X# X@ X#
+ P * ! * % *
E }
+27P0*!
+27P12*5!10*09%3*2!3*8&
Esc
00 – 32 (72) (00 = untied)
01 – 32 (72)
00 = auto (default)
00 – 32 (64) (00 = current configuration)
Response Additional
description
(switcher to host)
X# X%]
Set the re-clocker rate for
Rte *
output
]
Set the re-clocker for output 8
Rte08*00
to auto.
X%]
Show current re-clocker rate
X%
X&]
Command character is a
Spr
comma.
]
Save current ties as preset 9.
Spr9
X&]
Command character is a
Rpr
period.
]
Recall preset 5, which
Rpr05
becomes the current
configuration.
X&]
Spr Clear all ties in preset
X@ X# }
Enter as many ties as are
! ... * %
valid for this configuration.
X&]
Spr
The ! tie command, & tie,
and % tie commands are all
valid.
]
Clear all ties in preset 27.
Spr27
Brackets are shown to separate
ties for clarity only. Create
]
Spr27
global preset 27, which ties
input 12 to output 5, input 10
to output 9, input 3 to output
2, and input 3 to output 8.
01 = bypass
X# X%
to .
X#
for output .
X&
.